Commercial Shingle Sections · Frankfort

Frankfort Shingle Roof Coating

We apply shingle roof coating to commercial buildings in Frankfort when the shingles still lie flat: mansards, entry roofs, and church and office sections.

Crew in logo uniforms coating a shingle section of a commercial building in Frankfort, KY

Quick Facts

  • Shingle-rated coatings only
  • Shingle maker terms checked
  • Ventilation reviewed first
  • Commercial buildings only
Is This Roof A Fit?

Can This Shingle Roof Be Coated?

Shingle coating is a narrow fit. It works on shingles with years left and fails on shingles that are already curling.

What You See On The RoofCoatRepair Then CoatReplace
Flat shingles losing some granulesCoatRepair Then CoatReplace
A few lifted tabs or missing shinglesCoatRepair Then CoatReplace
Curled edges across most of the roofCoatRepair Then CoatReplace
Bald spots where the mat shows throughCoatRepair Then CoatReplace
Soft decking underfootCoatRepair Then CoatReplace
A shingle warranty that bars coatingsCoatRepair Then CoatReplace

A failing shingle roof needs replacement. Coating it only hides the problem for a short while.

Roof Conditions

What Shingle Roof Coating In Frankfort Checks First

On a commercial shingle section, these six spots decide whether coating is worth doing.

Roof plan, not to scale (Shingle section (ridge across the middle); Flat main roof). Numbered: 1 ridge cap; 2 screw rows; 3 end lap; 4 skylight panel; 5 eave gutter; 6 slope changeShingle section (ridge across the middle)Flat main roof123456
Plan view (not to scale). Numbers match the list.
  1. Ridge Shingles And Vents

    Cap shingles crack first and ridge vents must stay open. A coating cannot block the airflow the roof depends on.

  2. Granule Loss Across The Field

    Granules in the gutters show wear. Some loss suits a coating, and bare mat showing through calls for replacement.

  3. Lifted Or Curled Tabs

    Coating will not glue down curling shingles. Lifted tabs get sealed or replaced before anything else.

  4. Penetrations And Pipe Boots

    Cracked boots around vent pipes leak long before the shingles do. They get replaced as part of the prep.

  5. Eaves And Valleys

    Valleys carry the most water on a shingle roof. Worn valley shingles and metal get repaired before coating.

  6. Where Shingles Meet A Flat Roof

    Mansards and entry roofs often sit in front of a flat main roof. The joint between them is a common leak.

Shingle Coating Paths

Commercial Roof Coating Options for Frankfort

Three ways a commercial shingle section in Frankfort gets handled.

Shingle-Rated Coating

A coating made for asphalt shingles slows granule loss and adds reflectance on a roof that still lies flat.

Shingle Front, Metal Or Flat Behind

Many buildings have a shingle mansard on a flat or metal main roof. Each part gets its own system in one job.

About metal roof coating

Honest Replacement Call

When curled tabs and bare spots cover most of the roof, we say so and recommend replacement instead of a coating.

Repair Now, Coat Later

A shingle section with a few lifted tabs and one bad pipe boot can be repaired this year and coated once the rest of the building is ready for its own roof work.

Qualified Benefits

Benefits of Coating Your Roof

These hold only on shingles with real service life left and maker terms that allow coating.

Slower Granule Loss

The coating binds loose granules and shields the asphalt from sun, which is what wears shingles down.

A Lighter, Cooler Surface

Dark shingles absorb heat. A reflective coating lowers the surface temperature on a south-facing mansard.

Less Disruption Than A Re-Roof

No tear-off means no debris dropping beside entries at churches, offices, and storefronts.

Fewer Shingles In The Landfill

A shingle roof with years left stays in place instead of being stripped and hauled off.

Two Ways To Start

Shingle Roof Leaking Or Just Worn?

Shingle sections leak at boots and valleys first. Tell us what you are seeing.

Water At The Entry Or Ceiling

Call and describe where it shows up. Pipe boots and valleys are the usual cause on shingle sections.

Call Us

Granules In The Gutters

Granule loss without leaks is when coating is worth considering. Request an estimate first.

Get A Free Estimate
Shingle Job Steps

Steps On A Shingle Coating Job

The first step decides whether the job goes ahead at all.

  1. WALK

    Inspect Your Roof

    We check shingle condition, curl, bald spots, decking firmness, and ventilation, and read the shingle maker’s terms on coatings.

  2. FIX

    Repair Tabs, Boots, And Valleys

    Lifted tabs are sealed, missing shingles replaced, pipe boots swapped, and valley wear repaired.

  3. WASH

    Gentle Cleaning

    Low-pressure cleaning removes dirt and algae without stripping the granules the coating needs to grip.

  4. COAT

    Apply The Shingle Coating

    The shingle-rated coating goes on at the listed rate, with ridge vents and other openings kept clear.

Inspector checking screws and laps on a commercial metal roofRoofer explaining roof condition to a building owner
Related Services

Other Roofs On The Same Building

Shingle sections usually share a building with another roof type.

Crew applying silicone

Silicone Roof Coating

A flat main roof behind a shingle mansard often holds water, which points to silicone for that part.

See silicone coating
Crew sealing metal roof seams

Metal Roof Coating

Metal shop buildings behind a shingle storefront get the full rust and screw prep before coating.

See metal roof coating
Crew rolling acrylic

Acrylic Roof Coating

Pitched metal additions next to a shingle roof usually suit a white acrylic system.

See acrylic coating
Shingle Questions

Shingle Roof Coating Questions

Shingle coating raises more questions than any other system.

Does coating void a shingle warranty?

Some shingle makers void coverage once a coating goes on, so the warranty terms get read before any work. If coverage matters more than the coating benefits, the roof is left alone.

How does a coating affect attic or plenum ventilation?

A coating changes how the roof deck dries. Ridge vents and other openings stay clear, and the ventilation is checked during the inspection so moisture does not build up under the shingles.

How do I know my shingles are too far gone?

Curled edges across most of the roof, bald spots where the mat shows, lifted tabs everywhere, or soft decking all mean replacement is the honest answer.

Is shingle coating common on commercial buildings?

It is less common than metal or flat roof coating. It fits a specific case: a shingle section with years left that the owner wants to keep in service longer.

On most Frankfort commercial buildings, the shingle part is a mansard, an entry canopy, or a church wing, and the main roof is metal or flat.

Do shingle coatings come in colors?

Most are white or light gray for reflectance, and some makers offer other colors. Street-facing mansards often lead owners to pick a color that matches the building.

Find Out If Your Shingles Can Be Coated

Request a free estimate, and the roof walk tells you whether coating or replacement fits.

Call Us (502) 289-9862